Search results
-
Help with ignition lock removal - 1984 M1010
Good evening, I am having an issue with my ignition lock removal. The vehicle is a 1984 M1010 (Military Ambulance). All military trucks are keyed alike so in the interest of security I am trying to change out the ignition key lock and door locks. I have done this before on a M1009 (Military...- ballencd
- Thread
- Replies: 3
- Forum: Tech Discussion
-
Question on where to get a 6.2 fuel line feeding the lift pump?
I think I have a leak in the supply hose just before the lift pump on my 1984 K30 with a diesel 6.2 engine. It is molded and I can't find one anywhere. Any ideas?- ballencd
- Thread
- Replies: 3
- Forum: Tech Discussion
-
Oil Pressure Goes to Zero!
1991 Suburban V1500, 350 TBI, 700R4, Speed Hut gauge upgrade. Oil pressure sender installed in the port just above the oil filter mount. Vehicle is nearly a daily driver and runs fine. Just lately..in the last few days, I pulled a trailer with a tractor on it.....about 6000# total. When I...- ballencd
- Thread
- Replies: 33
- Forum: Engine & Performance
-
Speed Hut Speedometer Install....no signal error!
Hey Folks, I just installed a set of Speed Hut gauges in my 1991 V1500 Suburban, 5.7 TBI, electrical speedo, 700R4, 241. I have two (2) problems. Problem #1: I connected the input into the new speedo to the old pin 18 from the dash cluster plug....light blue/black stripe. I have tried both...- ballencd
- Thread
- Replies: 6
- Forum: Electrical & Audio
-
Strange Bracket in Serpentine setup 1991 Suburban V1500
Folks, Can anyone tell me what this extra bracket is for under my A/C compressor? It's on a 1991 Suburban V1500 with a 5.7 TBI engine. The bracket has not been drilled but there are spots that look like they should be drilled for pivots or mounting. Maybe for a second A/C compressor or a...- ballencd
- Thread
- Replies: 2
- Forum: Other Vehicles
-
700R4/241C leaking from vent?
I have a 1991 V1500 Suburban with a 350/700R4/241C. It appeared that the trans was leaking ATF but cleaned it all up and looked like it was coming from the top of the trans in the area of the transfer case vent. None coming out the tiny drain hole in the bell housing at all. So I opened the...- ballencd
- Thread
- Replies: 16
- Forum: Transmission & Transfer Case
-
Help with rear housing removal NP208
Hey folks, New to this site and hope I can get an idea on how to pull the rear housing on my 1988 V10 Suburban. I have new speedo gears to install and have removed drive shaft, speedo cable and 4 bolts on back of NP208 transfer case but cannot get the housing to budge. Any tricks known out...- ballencd
- Thread
- Replies: 3
- Forum: Transfer Case
