Search results
-
D
Clutch finger spacing
Does any know if there is a standard dimension that any or all pressure plate fingers sit off the flywheel face? Also does anyone know what the travel distance of the fingers (in inches) is required to disengage the clutch?- Dale A
- Thread
- Replies: 2
- Forum: Manual Transmission & Clutch
-
D
Running boards and fender flares
Anyone out there know where or who is selling the molded running boards that turn up and into wheel flare moldings both front and rear wheels? They were generally made of plastic or fiberglass. They had a recess at each door (like for burbs) for the step. Standard PU’s had a step in front of the...- Dale A
- Thread
- Replies: 1
- Forum: Aftermarket Accessories
-
D
Hydraulic clutch masters and slaves
Anyone aware of the relationship between the volume of fluid pushed by the master and what the slave requires for a proper operation when depressing the clutch peddle?- Dale A
- Thread
- Replies: 7
- Forum: Manual Transmission & Clutch
-
D
Engine starts and goes to full RPM???
I have been working on my 91 R 3500 for almost a year with it up on blocks. Doing a transmission swap, and install all new tie rods, brake pads, rotors and so on. So just got the trans in, an '03 zf 6 and went to start the engine. It immediately went to full race. Shut it off just as fast...- Dale A
- Thread
- Replies: 12
- Forum: Tech Discussion
-
D
New to Forums period
Been a SB guy since about '90. Currently have a 79 Royal Sierra Heavy Half 350/350 and a '91 R3500 with a 454/465. (Single rear tires) . One of the reason i decided to join at this time is I'm installing a zf 6s 650 trans in the 91 R3500. Having a time of it getting the hydraulics to work...- Dale A
- Thread
- dale a
- Replies: 11
- Forum: Introduction
