Search results

  1. hoagster

    Defrost vent measurements

    I had my dash recovered with upholstery and I installed after market Vintage air. I'm looking to add the defrost vents from and 81-87 but need their dimensions (size) before I pull the trigger. This is what I'm looking for available at LMC and a number of other places. @AyWoSch Motors do you...
  2. hoagster

    Need a recommendation from Chattanooga members

    My Son Blew his 4L60 transmission and needs to have it replaced or rebuilt anyone in the Chattanooga area have recommendation's for a Shop or rebuilder in that area!! Its in a 2011 silverado.
  3. hoagster

    Ammeter

    Ok I found the Ammeter replacement with a volt meter gauge discussion. But the person removed the ammeter and installed the voltage meter but wired it to the power and ground of the water temp gauge. I get it, but wouldn't it be easier to re-pin wires in my case a 73 year model; pins 105 and 106...
  4. hoagster

    Help finding a part, new or used

    Looking for the beauty ring that goes around the Steering column and sits against the instrument panel.
  5. hoagster

    Need honest quote for this truck, not a I know what I have?

    I have access to buying a new project, but I'm not going to! Family friend she is 83 years old, her husband passed in 2009. She has no idea how much this truck is worth. It was start disabled in 2007 (distributer wires disconnected) and hasn't moved from this spot because he tried to drive it in...
  6. hoagster

    Undercoat, or full on paint?

    I'm fixing to roll the cab on it's back. Going to strip a coat on rattle can primer, prep and spray epoxy primer. Question is after the primer is cured does it get base and clear? Or 3m 544 rubber undercoat, or some other undercoat and a finish?
  7. hoagster

    Fuel pump, sending unit grounds?

    Getting ready to run wire from my new tanks? Question is do I run the ground wires all the way to the cab or just to a good spot on the frame near the tanks?
  8. hoagster

    looking for images of clutch return springs SM465

    Doing a rebuild and when I removed the engine and transmission on my 73 K10 I wasn't paying attention looking for images from anyone that has a 350/sm475/np205 combo so I can see what the spring locations are on the clutch z-bar, pedal to frame etc, etc.
  9. hoagster

    Dana 44 open knuckle parts help (4x4 Spindle Shim)

    Hey guy's, rebuilding a Dana 44 front axle , small bearing spindle, total tear down. https://www.gmsquarebody.com/posts/497063/ passenger side I had a gasket between the knuckle and the spindle/disk brake housing assembly. Need help identifying this part! Can not find it in any parts...
  10. hoagster

    Bellhousing for a sm465 to LM7 5.3

    Can I use the old bellhousing from a SBC 350 converting to a LM7 5.3? Any suggestions if not? https://www.gmsquarebody.com/posts/452992/
  11. hoagster

    Started this yesterday

    New member, Owner of a family hand down 73 swb 4x4 c10 which I plan to make a daily driver then hand it down to my son, who will be involved with the build. Joined the site to share the build and pick some brains. The goal is to replace the original 350 cid, keep the 4 speed and transfer case...

Latest posts

Forum statistics

Threads
42,063
Posts
908,271
Members
33,542
Latest member
willyg
Top