There’s no way my 14ff cucv brakes outweighed my disc conversion. All of the disc components are less than half the weight of my drums alone....
The H pipe only equalizes pulses and maximizes scavenging based on all tests. Worst case scenario, the pulses can flow right on by if the velocity...
If you ever have a couple hours to kill and want to see how crazy a square body build can get...here us go!...
The PO did a rather crap job of painting(prepping) my truck. Noticed this when I got home today. Not really line-x’s fault—it’s still stuck to the...
1-1/4 ton rear leaf packs & shackles, k30 front leaves, ORD poly bushings and greasable bolts. Set of four kyb shocks. All in good shape,...
I see threads asking what this or that is worth and it’s kind of spread all over the place. I get it, people who may not be as knowledgeable in...
If I do the swap, yes. Although with what I’ve seen for shipping rates lately it may not make sense for us versus buying/selling locally. I will...
As far as I know there is only one Detroit locker and ARB for a 14ff. The options are pretty limited for the 14ff.
I recently had my D60 and 14ff completely rebuilt and a Detroit installed in the rear. Long story short, I want to pull the Detroit and put in an...
Damn, real nice!
It is, especially with a non-OD trans and less than 33” tire.
It only made my truck behave poorly when outside air temps were below 35 or so. I was getting MAT readings in the teens.
Yep, 4.10 is the cutoff. 4.10 & down is the only ARB for the 14ff, so I have to run thick gears to get numerically higher.
The PO swapped it to 3.73 and that’s what has been it the 9 or so years I’ve owned the truck.
Gotcha. Nice thing about the super low first and the fuel injection trying to maintain a constant idle speed is you can start letting the clutch...
In Michigan, I would advise against vortec heads with any wet manifold style injection ie a carb, sniper or any other tbi style injection. Fuel...
With my old headers I had one hole that I’d need to thread in the plug by hand, slip the socket over, then use an open wrench to turn the socket....
Solid
Do what makes you happy. If I had a 2wd there’d be nothing holding me back from lowering it a bit. These guys make really cool wheels for just...
I don’t see a problem lowering a 3/4 ton. They could potentially work harder. Lower center of gravity has more stability when towing or loaded....
That’s what I ended up doing. Although now it’s kind of a moot point from what I mentioned to you earlier today.
All valid points. The motor mounts are new as well. I wasn’t super clear about that other than saying everything is new. At this point everything...
I was one of the things I considered. I checked clearance, but maybe I missed something. I’d be curious to see a truck with the 4500 in it from...
Separate names with a comma.
