Firewall Cleanup : AC Install

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Bennyt

Full Access Member
Joined
May 17, 2019
Posts
1,020
Reaction score
1,403
Location
Surprise
First Name
Ben
Truck Year
1977
Truck Model
C10
Engine Size
350
I plan to shave my firewall with a panel from Vannatta as BennyT posted above. I figure as I am doing the cab repair, I might as well clean up the firewall.
Don't forget to weld a stud on the inside for the VA kit so you don't have bolt through firewall! Still can't believe I forgot, really it was the painter but I forgot to remind him the 10th time.
 

hoagster

Full Access Member
Joined
May 16, 2017
Posts
1,288
Reaction score
3,202
Location
California
First Name
Mike
Truck Year
1973, 2000
Truck Model
K10, 1500
Engine Size
5.3l
LOL... I think the same dude installed my original AC set up, there were some seriously jagged hacked in holes in the firewall and at the core support they just bent a knockout section to route the hoses through. Not to mention the rubiks cube to remove or install any of the heat or AC components which were separate stand alone systems.

I welded up everything on the firewall (almost) and cut down the Vintage Air adapter plate so it would be flush. I would probably have custom made new mounting brackets that bolt on the inside of the firewall if I had to do it again, or maybe just weld some studs to the firewall to slip the unit over. It was an all day job mounting the VA box under the dash for the final time, even after test fitting it without the AC & heater lines several times. Laying upside down and backwards while holding the box in just the right position for the bolts to line up just ended up causing fights.

IIRC the welded nuts in the VA brackets had galled jacked up threads, I think we ended up drilling one of them out and using a slightly longer bolt and nut.

Also, it was a bit of a PIA to mount the new firewall pad without any of the holes for the rubber plugs to push through. You'll want to replace the pad before your final install if you plan on replacing it at all.


You must be registered for see images attach


You must be registered for see images attach



You must be registered for see images attach
Nevermind posting another picture I found it, I see you didn't follow their directions either which called out 2" and 1 1/8" holes!! The grommets would fall out! I'm glad I read and re-read the directions then pulled out the grommets and measured everything. I like your setup but I don't have the skill in welding and body work that you guy's put into this! Awesome!!
 

CalSgt

Full Access Member
Joined
Oct 3, 2021
Posts
1,473
Reaction score
3,063
Location
CA
First Name
Casey
Truck Year
1980
Truck Model
Chevy K-10 Custom Deluxe
Engine Size
350
Nevermind posting another picture I found it, I see you didn't follow their directions either which called out 2" and 1 1/8" holes!! The grommets would fall out! I'm glad I read and re-read the directions then pulled out the grommets and measured everything. I like your setup but I don't have the skill in welding and body work that you guy's put into this! Awesome!!
Yeah I studied those instructions and re-read them until they made no sense.

Thanks for the complement Mike, we’re just a couple of kids with a welder and a lot of grinding disks.

Dad and I were looking at you firewall pictures and thought it turned out great, we both liked the 2 tone. The black kinda makes the metallic green pop.
 

Latest posts

Forum statistics

Threads
41,856
Posts
903,621
Members
33,370
Latest member
mitchell1128
Top