How much slip does the stock front driveshaft have?

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Pender1

Full Access Member
Joined
Nov 12, 2014
Posts
352
Reaction score
39
Location
SC
First Name
Brian
Truck Year
1986|2014
Truck Model
K5|1500
Engine Size
5.3L|5.3L
I moved the axle in my Blazer forward an inch and have just now gotten around to regearing it after my 14 bolt swap. The problem is my slip in the driveshaft seems to stop right about the time it gets to the yoke at ride height. Looking at the witness marks, it looks like it only goes about 2" from full compression before it stops (on what, I'm not sure). Does that sound right or is there something funky going on?
 

SquareRoot

Full Access Member
Joined
Mar 18, 2017
Posts
3,655
Reaction score
6,587
Location
Arizona
First Name
Mike
Truck Year
85
Truck Model
K20
Engine Size
350
I went thru this recently and conducted some in depth testing to confirm my front shaft movement. I was concerned about the shaft bottoming out after swapping in a D60.
The bottom line is it doesn't move as far as you would think. I unbolted the spring hangers (truck on jackstands) and let the front axle hang (full droop) and marked the shaft. Then I jacked up the axle against the bumpstops (full compression) and marked it again. Result:
From ride height the shaft only compresses 1/2 inch. On extension, it moves about 5/8th inch.
Conclusion, At ride height, unbolt the flange or u-bolts, slide the shaft forward and if you have at least 5/8" travel, call it good.

You must be registered for see images attach


You must be registered for see images attach
 

Pender1

Full Access Member
Joined
Nov 12, 2014
Posts
352
Reaction score
39
Location
SC
First Name
Brian
Truck Year
1986|2014
Truck Model
K5|1500
Engine Size
5.3L|5.3L
At ride height I seem to be at or slightly past full extension.
 

SquareRoot

Full Access Member
Joined
Mar 18, 2017
Posts
3,655
Reaction score
6,587
Location
Arizona
First Name
Mike
Truck Year
85
Truck Model
K20
Engine Size
350
I would do what I did just for piece of mind. You don't want the shaft coming out unexpectedly. Note that the shaft only moves one direction until the springs reach thier Apex (flat) then the direction reverses. That's why several inches of vertical movement only results in slight horizontal movement. It took me going thru the exercise to understand that.
 

Latest posts

Forum statistics

Threads
41,848
Posts
903,412
Members
33,362
Latest member
Dhatch84
Top