77 K10 LS Swap

Nicholson72 · Jan 8, 2019

O2 sensors can be a pain in the ass, I’ve had one throw a code every couple days then wouldn’t do it for a few months and then start doing it again and it’s been like 2 years since it threw a code for it lol

Madhorn · Jan 19, 2019

A small Saturday project. 6x9 cab corner speaker mounts.

You must be registered for see images attach

Madhorn · Jan 20, 2019

You must be registered for see images attach

Sounds great. With a 6x9 in each door and now one in each cab corner.

Camar068 · Jan 20, 2019

nice cut. As long as it's good to your ear, your good to go.

Madhorn · Feb 8, 2019

You must be registered for see images attach

Next project is to replace the tube/pipe cross member spacers with 1 3/4 square tube.

Madhorn · Feb 10, 2019

You must be registered for see images attach

Had time today to get the cross member spacers installed.

Nicholson72 · Feb 12, 2019

That looks good, I was thinking about doing that to mine to, the small spacers kinda messed up the frame

Madhorn · Mar 9, 2019

Front mud flaps was this weekends project.

You must be registered for see images attach

Madhorn · Mar 9, 2019

I have been researching AC components for a couple of months now. Found a shop willing to do the custom AC work and I worked closely with their tech making sure I order the correct parts. This morning I pulled the trigger on ordering parts. Vintage Air condenser kit, Vintage Air hose kit, ICT compressor bracket and compressor. Summit had everything I needed. Parts will be here this week. Once here I will get most the nut and bolt installation complete before taking it in to be completed.

Nicholson72 · Mar 12, 2019

Madhorn said:
I have been researching AC components for a couple of months now. Found a shop willing to do the custom AC work and I worked closely with their tech making sure I order the correct parts. This morning I pulled the trigger on ordering parts. Vintage Air condenser kit, Vintage Air hose kit, ICT compressor bracket and compressor. Summit had everything I needed. Parts will be here this week. Once here I will get most the nut and bolt installation complete before taking it in to be completed.

Nice how much you got in parts so far?

roundhouse · Mar 14, 2019

Nicholson72 said:
Nice how much you got in parts so far?

I spent about $1600 for the VA from Rutters rod shop in NC

Then had to buy the LS bracket that moves the Comp up top of the engine from some other place
Think it was $160

Madhorn · Mar 15, 2019

You must be registered for see images attach

So far about $800 in parts. Got started on the install this afternoon.

eskimomann209 · Mar 16, 2019

I’m jelly
I want the nv4500 in my SAS 98 c1500
I’m building an LS 383 stroker for it now

eskimomann209 · Mar 16, 2019

What was that little box below the wiper motor?

Madhorn · Mar 16, 2019

Part of the drive by wire throttle control. Throttle Control Actuator.

77 K10 LS Swap

Nicholson72

Member

Madhorn

Full Access Member

Madhorn

Full Access Member

Camar068

Supporting Member

Madhorn

Full Access Member

Madhorn

Full Access Member

Nicholson72

Member

Madhorn

Full Access Member

Madhorn

Full Access Member

Nicholson72

Member

roundhouse

Full Access Member

Madhorn

Full Access Member

eskimomann209

Full Access Member

eskimomann209

Full Access Member

Madhorn

Full Access Member

Similar threads

Latest posts

Forum statistics