-
-
straydog371 replied to the thread 1978-86 Rochester Fuel Filter Seal.I grabbed a few filter kits from here: https://quadrajetpower.com/short-fuel-filter-kit-with-spring-gasket-and-check-valve-1972-to-89/ -
-
I wouldn't put por 15 over a different coating,not how it was designed to work. It is designed to be used over phosphoric acid prepped...
-
straydog371 reacted to 1lejohn's post in the thread 8.1 Vortec VS 383 Stroker VS 6.0 Iron LS with
Like.
The 383 would basically be a new rebuilt engine. The stock fuel , and ignition system would work well for the 383. I would add long tube... -
I'm calling this a tool I made.... Squarebody cab cart.... used old pieces of a frame I had, so I could bolt the cab to the cart...
-
straydog371 reacted to Originalthor's post in the thread What have you done to your square lately?? with Like.
Bought some big tires for some reason. I'm no where's close to driving the thing lol.
-
Based on a tip from @andybflo i looked into Cheyenne Truck Parts and ended up ordering from them. Complete kit, dyed the correct...
-
straydog371 replied to the thread Parking Brake cable routing 131.5" C30 Dually.Maybe this will help (yellow highlight in picture)? It looks like there should be a longer loop hanger anchored in front of trans...
-
-
straydog371 replied to the thread What have you done to your square lately??.I took the box off with the intent of cleaning and painting the frame...the weather hasn't cooperated so I found a few other items...
-
-
straydog371 reacted to TotalyHucked's post in the thread What have you done to your square lately?? with Like.
Started mocking up the console
-
straydog371 replied to the thread Easton Is Graduating Thank You all for your help GMSB!!.Congratulations Easton! Well done Dad! You both set the bar high for all of us "Squarebody Restorers. Best of luck.
-
straydog371 reacted to Randy and Easton's post in the thread Easton Is Graduating Thank You all for your help GMSB!! with Like.
Easton is graduating in a few weeks and I had to reach out to y’all and say thank you for everything. We did not join the forum until...
-
straydog371 reacted to TotalyHucked's post in the thread I need help choosing a route for restoring my frame with Like.
While I had the engine and trans out for my swap, I just used various wire wheels chucked in a drill to clean the frame. Then went back...
-
straydog371 reacted to Bloodhound1981's post in the thread I need help choosing a route for restoring my frame with Like.
I wire wheeled, then used paint stripper attachment on angle grinder. After all that it and it was bare metal, I used KBS coatings...
-
straydog371 reacted to Scott91370's post in the thread I need help choosing a route for restoring my frame with Like.
When we did thge frame up on ours we sanded/wire wheeled it then POR15 Metal Prep then POR15. At the time (early 2020) it was about...
-
A ‘76 dual tank setup is relatively simple, but you just have to follow the wiring diagram and not try to reengineer it too much. First...
-
-
Loading…
-
Loading…
