Stormhawk
Latest activity Postings About
-
-
Stormhawk replied to the thread More Washer Pump Questions.I'll try this. Thanks. -
Stormhawk replied to the thread More Washer Pump Questions.That will probably be an option for another day, but right now I need a quick fix.
-
You can buy the newer reservoir and pump, ideally with check valve too, and install it where it goes on the newer trucks im pretty sure...
-
You should be able to- WHT 93 wire will brings 12 volts from the fuse box. PNK 94 goes back to the switch where it is grounded...
-
He said it’s silver and black, silver roof. So likely black stripe down the middle. But that’s totally an option. Or if it’s silver low...
-
Gents, I need to find a cost effective fix for my washer pump. Truck is an '83 K20 with the multi speed wiper switch on the dash. The...
-
Stormhawk replied to the thread Paint Source for 1983 K20.Grit, Yes, the rest of the truck is FAR from pristine, but is at least passable from 20 feet. The roof just sticks out like a sore...
-
Any paint and body supply can match it. But I’ll throw out another plug for Tamco paint. Still a great value. That said, @Stormhawk...
-
Gents, This spring I plan on repainting the roof on my 83' K20 as there's not a trace of paint left, and is nothing but rust and primer...
-
Stormhawk replied to the thread Choke Issues.So I eventually figured out what the problem was. When it was installed the kick off was behaving normally, pulling in under vacuum as...
-
Reading your post above it says you have to hold the choke plate open,if you let it close fully it dies.If the choke pull off is working...
-
Stormhawk replied to the thread Choke Issues.So more on this. I went out this morning after the truck had sat outside overnight. It was about 30 degrees out, so not terribly cold...
-
Think an 83 would have both a primary and secondary pull off. 3/16" gap on the choke plate is a good starting point for pull off...
-
That could possibly hide a bad choke pull off. The pull offs job is to pull the choke plate open as soon as there is vacuum.
-
Make sure non of your linkage is binding. Check that the choke pull off is connected and working. Make sure the diaphragm on the pull...
-
-
Loading…
-
Loading…
