Recent content by RoryH19
-
Kicking around doing an LS swap
To OP. Check my k5 build. I cover most of what you need to know. I run a LQ9 6.0LS/4L65E from an 04 Escalade and NP241c from a 90 burb along with the gauge cluster.- RoryH19
- Post #24
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
Kicking around doing an LS swap
I need to do the same for my t-case. What micro switch did you use and do you have any pics under the cover?- RoryH19
- Post #23
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
-
78 Cheyenne Owner/Restoration/Rebuild
Welcome from TX. I've been working on a 78 k10 Silverado swb for the last year or so. Off and on of course.- RoryH19
- Post #11
- Forum: Introduction
-
Door pocket
@AuroraGirl I always enjoy you long dialogs and appreciate you looking for the door pocket. You're the only one that has offered one. I really just need the door pocket. If the first one you showed is not cracked and still has flexibility that will work for me. Besides shipping will be much... -
Door pocket
Right. I have a feeling it would turn to dust when you try to move it. -
-
-
-
Door pocket
Hi, looking for an original door pocket for my 78 k10. I'm missing the passenger side. Interior is buckskin. No problem if faded, I'll redye as I did with the one in the picture. Thanks -
Front axle off set to passenger side
Ah that makes sense and what I was thinking. I'm sure it was faster to assemble on the line too.- RoryH19
- Post #99
- Forum: Suspension, Steering & Brakes
-
Front axle off set to passenger side
Does that mean the rad support and fenders were bolted together first? Then once the hood was square they would bolt the fenders at the back on each side?- RoryH19
- Post #97
- Forum: Suspension, Steering & Brakes
-
Has anyone superglued the copper contacts down on the circuit board ?
I have similar issues, about to buy a new circuit board for my 78 k10. I have a spare 82 cluster but LMC says they are different boards.- RoryH19
- Post #4
- Forum: Gauge, Speedo & Instrumentation
-
Seems like a good deal in the DFW area
That's for sure. Someone went overboard on accessories.- RoryH19
- Post #5
- Forum: eBay & Craiglist Listings
-
Front axle off set to passenger side
This is a good idea. I have a similar skewed issue on the right side of my 78 k10. No accidents but since every body part and the core support have been removed for various metal work. I assume the rear bumper is also a good reference point? How did the factory measure or square during assembly?- RoryH19
- Post #87
- Forum: Suspension, Steering & Brakes
