-
-
Be careful & precise when torching or plasma removing the perches & you'll ll be able to re-use them. Be advised that the width of the... -
^ which isn’t worth it for another 10 bolt, imo.
-
Raybob9289 replied to the thread 6.0 NV4500 K30 swap.I ended up using the 2001 Suburban 2500 Hi-pressure hose. Fits great at the pump.. Then I cut off the metric end that goes into the...
-
-
Raybob9289 replied to the thread 2000s hydroboost into a square.Did you use the original high pressure hose??
-
Raybob9289 replied to the thread 6.0 NV4500 K30 swap.Which pressure hose are you LS swap guys using on the Hydroboost. My original (1977) is about due and It don't seam to fit back behind...
-
Which pressure hose are you LS swap guys using on the Hydroboost. My original (1977) is about due and It don't seam to fit back behind...
-
It was called "Ochre" IIRC.
-
I think I've posted this before and if there is a thread onthis topic please except my apologies. I am looking for the yellow color that...
-
Raybob9289 replied to the thread 6.0 NV4500 K30 swap.Lunch Debreifing; I went back to the adjustable engine mounts. Moved the engine 2" forward. NV4500 shifter is now easily out of the way...
-
-
The ORD mounts will place the rear of an LS block in the same place as the SBC block...
-
Raybob9289 replied to the thread 6.0 NV4500 K30 swap.The 454 clutch fan?? I'm using the screw on clutch fan from the 6.0 out of the the Burb
-
From experience (not the LS) I would move it forward and have at least an inch from the firewall. The shifter is gonna require a new...
-
Raybob9289 reacted to hoagster's post in the thread LQ4 Swap, starter wire routing question with
Like.
Try this again, You also have the battery wires running in the same spot, There is a protection plastic cover that attaches in the... -
Raybob9289 reacted to Drauka99's post in the thread 1981 C10, 6.0 LQ4 swap with Manual Trans Exhaust Question with Like.
Ok so on the passenger side, using the stock manifolds. you can get flanges from summit. I used those. One ear on the passenger side...
-
Raybob9289 replied to the thread 6.0 NV4500 K30 swap.I'm only worried about the NV4500 shifter position and making sure the stock 6.0 fan fits in the original 4 core fan shroud. I'm...
-
-
Loading…
-
Loading…
