Recent content by nyceguy01
-
N
Air Spring kit Major Fabrication Required
Timbren SES will fit and you wont need to deal with air... Ill never do airbags again..- nyceguy01
- Post #7
- Forum: Lowered & Street Systems
-
N
New Process A833 4speed w/ OD MY6 MM7
Still looking ?- nyceguy01
- Post #311
- Forum: Manual Transmission & Clutch
-
N
Tank replacement for EFI
I used a tank and Pump from tanksinc.com nice stuff- nyceguy01
- Post #18
- Forum: Tech Discussion
-
N
Aftermarket trans crossmembers
Cheap, easy, works great..... https://www.summitracing.com/parts/trd-6421- nyceguy01
- Post #22
- Forum: Transmission & Transfer Case
-
N
Spindle and rotor issue
yep. Spins great. I ground out a large washer from the nut and bolt bin just to test it and with the extra thickness and it seems fine. I just dont like the idea of an extra washer in there. I also tried the same bearings and rotor on the other spindle from the kit and its good to go as is...- nyceguy01
- Post #5
- Forum: Lowered & Street Systems
-
N
Spindle and rotor issue
Thanks... My best guess here is that when the spud was pressed in it was pushed slightly too far...- nyceguy01
- Post #3
- Forum: Lowered & Street Systems
-
N
Spindle and rotor issue
I have an 85 C10. I bought a set of spindles from Chassis tech. I figured while I was at it I might as well get new Rotors, bearings, seals etc... Upon assembly there is an issue and Im not sure if the Spindle is wrong or if its the rotor etc.. It seems like the slot in the threaded portion of...- nyceguy01
- Thread
- Replies: 5
- Forum: Lowered & Street Systems
