-
-
Logbed replied to the thread Heater Hose Routing.Hi, figuring out the same things. The one heater hose goes to the radiator top. I had the other heater hose go to the intake with the... -
-
Logbed reacted to bucket's post in the thread Does 33x12.50R15 fit at the rear of a 2wd C10 with stock suspension, stock 8x15 wheels with
Like.
400+hp and burnouts is always risky with the 10 bolt rear, no matter the tire size. As long as it doesn't wheel hop or do anything else... -
Logbed replied to the thread Does 33x12.50R15 fit at the rear of a 2wd C10 with stock suspension, stock 8x15 wheels.Its garage season here, I have not yet swapped the tires. I installed the lift up front, ended up lifting 1,5 inches. Still not made up...
-
Logbed replied to the thread Collapsed upper radiator hose.Just replacing my hoses. Do the normal spare part hoses come with a spring? My old lower hose is pretty soft, are the spare part hoses...
-
Logbed posted the thread Quick and easy engine rear support when transmission is removed? in Engine Swaps (Gas) LS, Vortec, LT1 , etc..I'm going to isntall the sbc engine now but the TH700 will be ready later. The rear of the engine needs support for a while. Would be...
-
Logbed replied to the thread Mechanical fuel pump return line.How should I tell the difference? In my '85 truck there is a smaller metal line right below the fuel line and it was not connected to...
-
Logbed replied to the thread Engine mount, old or new?.Things turned out so that the Anchors were not available. The cracked rear mount convinced me not to buy far east rubber, so I Installed...
-
I'm in a process of swapping the engine. My previous engine and fuel pump did not use the return line. Actually I just found the line...
-
Hi, I have the box (Saginaw 800) on the table, just replaced the pitman shaft seals, put the shaft back in and now I should adjust the...
-
I used these in the factory metal "clam shells" for my 78 C10 ...
-
I usually replaced the mounts. Many times upper bracket attached to the block will be laying hard against the cross member or frame...
-
I think it always pay off to go with new, but spend some time looking for a higher quality product. Maybe the off-road vendors sell...
-
Logbed replied to the thread Engine mount, old or new?.I ordered OEM style Anchor mounts. Lets hope they are good.
-
Rubber ages and with 40 years it's pretty dead. I had to replace the engine mounts on all old vehicles I owned. Some were terrible worn...
-
I have heard two opinions 1. Old OEM after 40 years is still better than new chinese 2. Replace them as the engine is out now. Its not...
-
-
-
Loading…
-
Loading…
