-
-
JKRamsey1991 replied to the thread Engine Rebuild Kit Recommendations.I would get out some calipers/mics and really start measuring everything. It its really tight something is most likely wrong. Make sure... -
JKRamsey1991 reacted to jjester6000's post in the thread Might have Over-torqued Rod Bolts 250 I6 with
Like.
Engine is in!!! I'm going to finish everything up tomorrow, but I did hook the starter/oil pressure line up and it spit out about 45lbs... -
JKRamsey1991 replied to the thread Engine Rebuild Kit Recommendations.I am currently buttoning up the rebuild on my small block. I found it was cheaper to piece together a the stuff than buy a kit if doing...
-
Came onto this forum months ago for help because the '77 GMC Sierra Grande my neighbor gifted me last November was dieseling when I shut...
-
JKRamsey1991 replied to the thread 1986 Engine Wiring Question.Well maybe I called the module the incorrect name. It is the Emission Control Module not technically the AIR module.
-
JKRamsey1991 replied to the thread 1986 Engine Wiring Question.I'm with you really. I have no clue how the AIR module works or any of that. It just appears the white/brown wire is the 12volt feed to...
-
JKRamsey1991 replied to the thread 1986 Engine Wiring Question.I guess everyone is about like me and hates wiring/wiring diagrams lol.
-
As I am in the process of rebuilding the engine in my truck I wanted to clean up the wiring while I am able. My truck has all of the...
-
-
JKRamsey1991 replied to the thread SBC Cylinder Head Decision.The motor is coming out of the truck in a couple weekends. Will tear it down and decide from there. Based on the feedback probably will...
-
JKRamsey1991 replied to the thread Engine swap.As long as it is not a reverse rotation marine engine it should swap in. Id try to find the specs on the cam before assuming it needed...
-
I ran a Comp 270H on a 400ci SBC in my '57 Chevy for years. Great cam in that car. In my '76 K20 I'm building, it too has a 400, but...
-
JKRamsey1991 replied to the thread SBC Cylinder Head Decision.Truck has 4:10 gears in it so I can get by with a bit more cam. From what I have been researching was leaning towards a cam similarly...
-
I have the assembled Brodix IK 180 with a low/mid range torque roller cam and cevrolet performance intake. I can't say anything about...
-
Engine Masters has an episode that compares heads for what you are describing. AFR 195 wins every time.
-
JKRamsey1991 replied to the thread SBC Cylinder Head Decision.They compared the Speedmaster, AFR and the Summit head. The summit is supposedly made by Brodix so I guess it compares two of the three...
-
-
Loading…
-
Loading…
