-
-
Jjfrancom101 replied to the thread Carb sprays gas into the air?.Sweet! Thanks so much!
-
JIt can be fairly small. OE wire is probably 14-16ga.
-
Jjfrancom101 replied to the thread Carb sprays gas into the air?.Just a quick question. I'm finally getting back to the carb, I was having issues with the tranny so the carb became less of an issue...
-
Jjfrancom101 replied to the thread TH400 issues.Awesome! That happens to be the filter I already got :D
-
JThe filter you need is an ACDelco TF231. If you can see filter media in the small hole on the bottom, it is the wrong filter and can...
-
Jjfrancom101 replied to the thread TH400 issues.Perfect Thanks for the info! I guess the modulator is the only more urgent one, I think the kickdown isn't as urgent because I never...
-
JThe donut thing is a magnet. It collects the debris and keeps it out of the filter. There will always be some stuff stuck to the magnet...
-
Jjfrancom101 replied to the thread TH400 issues.Also other question, The fluid looks great except a small film of darker sludge at the bottom of the pan, is that ok Also while dropping...
-
-
Jjfrancom101 replied to the thread TH400 issues.Sweet! thanks! do you by chance have a picture of what the vacuum port plugs into? I have an edelbrock carb.
-
JThe vacuum can is your modulator. It should be a hardline to a vacuum source on the intake manifold between the carb and distributor. It...
-
Jjfrancom101 replied to the thread TH400 issues.So I'm changing the fluid and everything today. I found this sensor and the wire connected to it runs towards the torque converter and...
-
-
Jjfrancom101 replied to the thread TH400 issues.Yeah I'm wondering about rusty brakes. I did replace the calipers, shoes, and master cylinder for the front and the back ones don't seem...
-
Jid say your truck had sticking brakes and perhaps rusty or something.. or the trans slipped a lot trying but once free it wasnt bad...
-
Jjfrancom101 replied to the thread TH400 issues.So update on my truck. I went out there today, I loosened the bleeders on the front brakes and there was still resistance but with a...
-
Jjfrancom101 replied to the thread TH400 issues.So I don't see any obvious messed up lines. the fluid level is good. I'll climb under the truck to take a better look. Right now it is...
-
-
Loading…
-
Loading…
