Recent content by Clovis
-
Any recommendations for a new dash bezel?
I got one form lmc pricey but good quality and covered the big hole in my dash that someone cut for a single din radio -
CNC machined emblems
Huge hole in Billet emblems for square body’s I would love a set for my 87 gmc front grill look for some every so often never can find any -
New truck
That’s what I plan to use the template is kinda expensive but I think it’s worth it- Clovis
- Post #10
- Forum: Introduction
-
-
New truck
trim rings and hub caps came in today for a set a rally’s I robbed my buddy for now need to find some tires. Do a little tune up get it running the best I can then short bed conversion.- Clovis
- Post #6
- Forum: Introduction
-
New truck
Not a new member but I got a new truck. Picked up this 81 long bed 305/350 for 2k. Lucky enough I also picked up a short box for cheep too. Chop coming soon- Clovis
- Thread
- Replies: 9
- Forum: Introduction
-
AC troubleshooting
Try and turn the pulley and clutch by hand if they turn put the belt see what happens. Maybe check to make sure the compressor still has oil. The 134r conversation is easy the adapters screw right into the ports already there. Check to make sure it will hold vacuum before you add refrigerant.- Clovis
- Post #2
- Forum: Tech Discussion
-
What did you pay for a square
I payed 3k for my 87 Sierra classic in may of 2020. After lots of work I made it from this. (picture taken the day I bought it) To this- Clovis
- Post #145
- Forum: Tech Discussion
-
Recent 85 Sierra Classic Inheritance
My short bed twin love the truck- Clovis
- Post #18
- Forum: Introduction
-
A/C and Cruise Control Vacuum Source
But why is it needed why not just run a elbow to delete it instead of a T- Clovis
- Post #27
- Forum: Tech Discussion
-
A/C and Cruise Control Vacuum Source
I just got my a/c running this Saturday! It was about $350 all said and done I replaced the compressor, blower motor, and the dryer. I needed the belt too mine was running a shorter one to delete the compressor. I did notice the line to the accumulator was ripped I replaced it already but what’s...- Clovis
- Post #20
- Forum: Tech Discussion
-
Returning after a few year hiatus
I love the cream color. Are you planning to put a new transmission Like 4L65 or 4L80?- Clovis
- Post #9
- Forum: Introduction
-
New member in new mexico
What’s up bro I’m the mentioned new member from nm my name is Clovis but I’m from Roswell- Clovis
- Post #10
- Forum: Introduction
-
1987 GMC Sierra classic
Well I talked to the guy I bought the truck from and he said he had to re-wire the starter before so to check there and sure enough I could see the wires spark inside the crimped connecter I could tell that that power is ran to the starter then from there out to the rest of the trucks- Clovis
- Post #12
- Forum: Introduction
-
1987 GMC Sierra classic
Thanks for the complements and tips guys no it’s not a show it’s just a bunch of my buddies the inside is a little ruff so I plan to Start there with it as I fix whatever happens to break I already had a lower ball joint separate- Clovis
- Post #9
- Forum: Introduction
