CalSgt's latest activity
-
Csame here no noise! :)
-
CEP381 pumps in my tanks. Silent. All new factory setup.
-
CCalSgt reacted to Grit dog's post in the thread Need advice for doing Kilmat/Boomat/Dynomat with
Like.
@C10SLEY sounds like a good plan. I didn’t take any pictures but did the same as @CalSgt except I didn’t do under the seat area as the... -
CCalSgt reacted to Scott91370's post in the thread Need advice for doing Kilmat/Boomat/Dynomat with Like.
I wold wait until you are sure you're going to do repairs or not. Even with dry ice it's a lot of work getting it out. I covered my...
-
CI run pwm controller that is referenced by map sensor on one of the vehicles to get pump to lower output at low load.
-
CCalSgt replied to the thread Need advice for doing Kilmat/Boomat/Dynomat.Yeah basically... The stuff is so expensive I watched a lot of videos and read every manufacturers info before I purchased. The first...
-
CCalSgt replied to the thread Need advice for doing Kilmat/Boomat/Dynomat.If you think you'll pull the cab & restore it you could always scrape up the sound dampening to accommodate repairs if needed...
-
-
CWell the principles of the combustion engine on newer rigs are the same as the older ones, if you think of it like that maybe it won't...
-
C9 inches of lift , 8 inch springs with 1 inch 0 rate blocks, crossover steering a must in my opinion, 38's with a little fender trim and...
-
CCalSgt replied to the thread What size lift to clear 40s?.^^^^^ This I hate body lifts but if I wanted to run giant tires with minimal rubbing I'd consider a 1" or 2" body lift before trimming...
-
CCalSgt reacted to nvrenuf's post in the thread Whats the going rate for shortening a driveshaft? I think I got....shafted with Like.
@SquareRoot @Frankenchevy my rear shaft angle caused a lot of vibration and shims didn’t do enough so I went with the CV style now. The...
-
CIf you wheel it hard and/or have a flexy suspension it'll rub but if on the street or light wheeling you can get away with a light trim...
-
CCalSgt replied to the thread Center hump.I'm pretty sure this '81-'83 high hump is the one my Dad retrofitted in my 1980 4wd, it didn't ever fit perfect but we were able to make...
-
-
CCalSgt replied to the thread Silencing electric fuel pumps.Maybe that's my problem... There's only a few gallons of gas in each tank so I could test the system and get the engine started.
-
CCalSgt reacted to TotalyHucked's post in the thread What have you done to your square lately?? with Like.
Gave mine a bath yesterday after doing 4500mi to AZ and back lol
