Search results
-
7
Bench Seat Hardware
Seems like the bottom of the seat hits before it can slide all the way back. Also there is a lot of play in the sliders so if you jiggle the seat there's quite a bit of play. Anyway to tighten it up? I saw in lmc truck there's a support spring that mine doesn't have -
7
1973 K10 Differential and transfer case fluid
Hey I need similar advice but can't post yet. I have a 75 k10 that has been worked on in the past. It's a auto 3 speed on the floor. To my information the tranny is a 350 turbo. What fluids do I need and how much for t case, transmission and differential Front and rear ? Thanks- 75Beast
- Post #8
- Forum: Front Diff & Hubs
-
7
10 Bolt Front Axle Gear Oil Change
Same fluids for a 12 bolt? Same technique for the front axle?- 75Beast
- Post #26
- Forum: Front Diff & Hubs
-
7
10 Bolt Front Axle Gear Oil Change
You have to remove cap to change fluid. No drain plug?- 75Beast
- Post #25
- Forum: Front Diff & Hubs
-
7
Squarebody Differentials.
Squarebody Differnetials. What type and how much fluid goes in a 1975 k10 front and rear diff?- 75Beast
- Post #101
- Forum: Differential & Driveline
-
7
NP241C Tranfer Case Fluid Change
How did it drain out the bottom plug if the plug is inserted and tight?- 75Beast
- Post #9
- Forum: Transfer Case
-
7
Bench Seat Hardware
Hey so I went to the junk yard and found sliders. Piece of cake! However now I can't get the slider to go all the way back. Also the wire that travels from the driver side to the passenger side is loose and doesn't pull the passenger latch. any easy fixes to these two problems? -
7
seat swapping?!
if anyone has the hardware for a bench seat I'm looking to purchase -
7
Bench Seat Hardware
Are they just bolted on there? How difficult would it be to fabricate something similar? -
7
Bench Seat Hardware
So i have a 75 that originally had a sliding bench seat which i took out and threw in some buckets out of a jimmy and had a custom metal console built. The setup is pretty sweet, but i want to go back to the classic bench seat look. However, when i put the buckets in i had the mounting hardware...
