Search results
-
-
Connector Question
I just installed a new radio, and it requires a constant 12v for the preset memory. I’d like to use a connector as pictured, as it’d look proper. Any one know of a place to look, or a part #?- Mory Rugg
- Thread
- Replies: 4
- Forum: Electrical & Audio
-
Anyone use these guys for carpet kits?
I just ordered a carpet set from USA1interiors. I could have probably found something cheaper, but they were nice to work with over the phone. Also my pickup has the factory “mystic” white interior door panels/ door pillars/ trim and they are the only place I know that carries that color... -
-
NP205 Speedometer Issue
After some research and investigation, it would appear that I have a driven gear issue. As I separated the speedo cable and took off what I believe is a ratio adapter, they all appear to be in working condition (the cable spins the speedometer and the adapter turns as well). So this leaves the...- Mory Rugg
- Thread
- speedometer
- Replies: 4
- Forum: Transfer Case
-
Hello from North Dakota
I've been on here for a bit, I just wanted to thank everyone and the site management/ownership for the creation and maintenance of such a great resource! Mory- Mory Rugg
- Thread
- Replies: 10
- Forum: Introduction
-
-
1980 Oyster White
Thanks Swims350! I’ve seen it on a Vette forum, is just thought I’d ask here. I’ve never been a big fan of the whole interior being Carmine Red, but the combination actually looks pretty cool. I just want to update the door panels as they are showing some wear. Thanks for everyone’s help! -
1980 Oyster White
What’s amazing is it’s lived in ND it’s whole life. I’m the 4th owner. Original owner until 04, second owner until 07, and I purchased it last year. -
1980 Oyster White
Anyone know where I can obtain dye for the 80 Oyster White? My K10 has a somewhat rare color combination with the Carmine Red/Oyster White color combo. Also has anyone seen door speaker housings like this before? It looks stock but I have never seen them before. -
Cruise Control Transducer
I know, from what I’ve seen they run around $100.- Mory Rugg
- Post #3
- Forum: Engine & Performance
-
Cruise Control Transducer
I’ve got an 80 K10 and the cruise control transducer is bad. It’s a two terminal Cardone 36-101 part, and I’ve searched the interwebs and have only found some on some sketchy websites. Does anyone have a recommendation on where to purchase one? Thanks in advance!- Mory Rugg
- Thread
- Replies: 5
- Forum: Engine & Performance
-
Warn 20990 hub installation
Thanks for the replies! I tried the hub in both rotors, the one fit in both, the other didn’t. I contacted Warn just to ask if they ever ran across this, they said sometimes but it’s rare. After surveying many forums, I’ve decided to stick with the original Spicers. The Warns are boxed up...- Mory Rugg
- Post #4
- Forum: Differential & Driveline
-
Warn 20990 hub installation
Has anyone experienced this phenomenon? Replaced ball joints, bearings and was going to install new hubs....then ran into this. One assembly fits, the other doesn’t.- Mory Rugg
- Thread
- Replies: 3
- Forum: Differential & Driveline
