Search results
-
1
Edelbrock 1405
Its heat soak, Eddy's are notorious for it. You can try a 1" phenoulic spacer but if the motor is punched out .040 or more you may still have issues with it. You can also try a fuel cooler as well, check the routing of your fuel lines and try to keep them away from hot surfaces like exhaust...- 1985Bubbatruk
- Post #8
- Forum: Engine & Performance
-
1
New guy here!!! Need some carb help
@ 74 Shotrbed, is correct if you have a TH350 you have kick down.- 1985Bubbatruk
- Post #15
- Forum: Introduction
-
1
New guy here!!! Need some carb help
And yes the TH350 pan has 13 bolts but an easier way to tell is by the shape. TH350 is a square with one conner cut off the 700R4 is a square and the TH400 is an odd shaped looking Texas.- 1985Bubbatruk
- Post #10
- Forum: Introduction
-
1
New guy here!!! Need some carb help
Post a pic of the pan. Then we can verify for ya. Is the modulator on the back passenger side( pointed towards the rear axle) or up by the starter pointed towards the passenger door?- 1985Bubbatruk
- Post #9
- Forum: Introduction
-
1
New guy here!!! Need some carb help
By the looks of the TV cable you have a 700R4 trans not a TH350. You should be able to get the correct adapters from your local auto parts store. I would move the throttle to the big hole on the top, will work bettr up there. The bracket you have should work fine, I have the same on my truck and...- 1985Bubbatruk
- Post #7
- Forum: Introduction
-
1
Please help!!! Clutch/Tranny Issues
Not sure about the clutch issue mine has a manual clutch in it, but as far as the shifter goes, Yes the slots have to be in the center for the shift lever to go down in the top correctly. You should be able to use a long screw driver or prybar and move the shift rails ito position, then drop you...- 1985Bubbatruk
- Post #15
- Forum: Transmission & Transfer Case
