Search results
-
B
Vortec swap egr to pass emissions
I dropped a vortec in my truck. Threw the performer RPM manifold and a Performer 600 carb. I didn't think through the whole thing, because now I need to figure out how to do an EGR valve to get it through emissions. I am sure I am not the only one to be in this spot... any suggestions? Thank...- banditti
- Thread
- Replies: 0
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
B
Tilt question
I would swap the wheel for sure. I am looking to match options for options. I just want a cost effective tilt upgrade! -
B
Tilt question
Will a tilt column from a 80-92 chevy caprice fit in my 77 c10? -
B
Electrical Gremlins
Unfortunately, still doing it. Fuses seem ok. At least my fluke says so ;) Going to check ignition switch and connector this morn- banditti
- Post #3
- Forum: Electrical & Audio
-
B
Electrical Gremlins
I have a '77 C10, bought the truck a couple of months ago and it has been running fine. Yesterday, started it up and it idled for a couple of minutes. Threw it in gear and it is like the electrical died. Wouldn't turn over. Lights, etc. pretty much everything but the gauges dead. Took the...- banditti
- Thread
- Replies: 7
- Forum: Electrical & Audio
-
B
A/C later model controls
Is it a good unit? Maybe I should leave well enough alone and rebuild what I have? I'd like the controls in one panel, but maybe it isn't worth it? -
B
A/C later model controls
Thanks! Learn something new everyday. Find a factory doner from a yard and grab all the parts? -
B
A/C later model controls
Hello!! New square body owner and new member. I have a 1977 C10 with factory A/C. It has the A/C controls above the heater controls. A couple of questions: 1. Can I convert it to a later model C10 that has the heater and A/C in the same control unit? 2. This truck sat for about a...
