Recent content by yevgenievich

  1. yevgenievich

    8.1 Vortec VS 383 Stroker VS 6.0 Iron LS

    There are aftermarket mpfi intakes for a bbc that will run on 411 ecu if going away from l29 intake manifold. Or 8.1l with stock intake will work well for most uses.
  2. yevgenievich

    8.1 Vortec VS 383 Stroker VS 6.0 Iron LS

    Gen6 454 would be good to consider as well. Big block or 383 will have better low end torque than a stock 6.0 ls
  3. yevgenievich

    Adding a headrest to a bench seat

    Head rests on GMT 400 bench work for the height
  4. yevgenievich

    Catch Cans

    That is 8.0l bbc with brodix race rite heads. I am also running a pcv valve with check valve from a turbo solstice. Were left over parts from when I sold that one.
  5. yevgenievich

    Catch Cans

    I am running efi with maf. After the maf, line goes to one of the valve covers then goes out from other side with pcv valve in to a catch can. From there to intake manifold.
  6. yevgenievich

    Catch Cans

    Depends on the engine. I get some oil in the catch can. On burban mostly because valve covers are spliced from two and relatively large ring gap(for boost)
  7. yevgenievich

    Catch Cans

    Running one connected on output of pcv valve.
  8. yevgenievich

    stealth

    Forced ventilation and existing dust on the shelves. Everything that I cared for was covered, the rest did not realy get any overspray with a forced blower pulling air out. Will have to set up painting again once I deal with the fender
  9. yevgenievich

    stealth

    Had to recently replace clutch slave and a line as it started to leak. Then get hit and run while parked. It is pretty evident who did it, but hard to prove.
  10. yevgenievich

    Transmission Upgrade?

    4l80e would be the likely choice. 6 speed would allow to have steeper 1st gear for quick take off. I was getting about 12mpg with gen6 454 and 4l80e in a 4x4 suburban(33" tire). At one time had a 2wd crew cab with gen6 454 and nv4500 that would get up to 16-17mpg. Currently with a 488 motor in...
  11. yevgenievich

    Under-pad replacement suggestions?

    I used regular carpet jute for houses before. Seem to work fine
  12. yevgenievich

    89 Trans Am

    Finally getting some finishing pieces on interior. New rear 6x9 speakers installed, new sail speaker covers, put pillar trim back on, kick panels, under bumper plastics. Need to close out back seat area and front seat belt guides
  13. yevgenievich

    Train wreck

    Sunroof service.
  14. yevgenievich

    Rear wheels are sucked in way more than front. K10. Adapters? BAD IDEA? pics inside

    Gmt400 kept narrow rear track as well. And gm had opposing advertising claiming different track width better traction
  15. yevgenievich

    99 tahoe shorty

    Arteb headlights installed(euro light pattern). Need to aim still. My strategy on installing lights had been loosely mounting the base, then test fitting the grille. While grille is on, there is enough access to tighten one of the headlight base bracket bolts. That sets lights in place and the...
See more

Latest posts

Forum statistics

Threads
42,109
Posts
909,270
Members
33,595
Latest member
T3rraBeara
Top