All so with ml 60 and 80.the sunshields crack strip.go bad.they hold a clutch pack.it and a few other parts have to be replaced
With aftermarket parts.like the beast sunshield..they have a oiling problem too
Chevy could never fix or figure out the problem.
There is only two real transmission,s
TH 400.or a TH 700 with out computer.
These two are strong.never ever go with a ml60 electronic or a ML 80 Electronic
They are defective from the factory.you may could buy one cutom built.but why would you want a trans that has to use a computer.
With...
The 400 motor. Is crap.just a scam.to ad some pickup.to a new big car.like a Caprice or impala
If I remember right.they took a 350 V8 block and bored it out.making the cylinder,s
Simees..the center of the cylinder.is thin and the head gaskets would blow and the engine.would blow a gap
From...
It's not rocket science..two things kill oil
Heat and dirt.if you race or do hard use.or you do not change the filter.say every two thousand miles.
You notice the vehicle still comes with just one engine filter.not two or three.they want the engines to go out.
Because of oil.kill the...
You could have the distributor out.the rotor button has to point to number one plug.on the compression stroke.make sure all wiring is tight.wires on the starter too.you can ground the end of a plug on the exhaust manifold.to see if it is firing.see if a plug is wet with gas.
Did you ever pull the TBI off and clean it up and put a kit in it.when I pulled mind.the base gasket was messed up.broke up some.you can get the rebuild kit.from different places.rockauto.maybe eBay.
Am I wrong.at 30 over.thats it for the block.or can you go 40 over.i would use the best head gaskets you can get and seal it up tight.new head bolts intake bolts and torgue it right..maybe use some red loctight too.
A wire that was naked and shorting.could of killed your battery.there is a burnt wire some where.keep the battery un done.to you find it.
You are lucky there was not a fire.
Taking the radiator out would give you some extra room.but if you are a slim guy.dont sweet it.
Get a cover with a gasket kit.it should have the two short pieces.for the front edges of the oil pan.you take a razor knife.cut those tips off.
Remove the belts.the fan and bottom pull and harmonic...