Recent content by squarebodyn8tion
-
S
1977 k20 build
yea its in 2h. spun the rear wheel loading it on the trailer- squarebodyn8tion
- Post #12
- Forum: Introduction
-
S
1977 k20 build
I counted the gears and im pretty positive its shifting into all 3 but 2-3 was a short gap. the issues happen at idle as well so I don't think the trans is the issue there.- squarebodyn8tion
- Post #9
- Forum: Introduction
-
S
1977 k20 build
everything seemed fine when I assembled it, one wrist pin was a bit tighter than the rest but wasn't horrible. what more of a pain in the ass. pulling the entire motor or yanking everything off the front end to get to the cam- squarebodyn8tion
- Post #4
- Forum: Introduction
-
S
1977 k20 build
Hows it going everyone, Picked up a project a few weeks back. its a 1977 single cab long bed. 8" lift 36.5" swampers, pretty solid besides a small part in the firewall, inside cab corners tucked back, and the drivers side door corner. i received the engine in 100000 pieces, with an...- squarebodyn8tion
- Thread
- Replies: 15
- Forum: Introduction
