Recent content by Shamrock Motors

  1. S

    New Process A833 4speed w/ OD MY6 MM7

    Hello all I now have the A833 transmission and associated parts out of the truck if anyone is interested. I am trying to recall who had expressed interest a few months back. They were from north Dakota I beleive. So if anyone needs one, no reasonable offer refused.
  2. S

    K Case 4x4 700R4 core wanted

    Thanks but thry are not as common as you might think
  3. S

    K Case 4x4 700R4 core wanted

    Hello, I am in Westchester County New York and am looking for a 700 R4 K case 4x4 core. Meaning a rebuildable transmission for a 1986 K10 pickup. Anyone local know of one ? Thanks
  4. S

    New Process A833 4speed w/ OD MY6 MM7

    Hey thanks all. That's a relief to know it will all bolt in. I just want to make sure the cross member does not have to be changed ? Last I checked the a 833 was 27 1/2 inches and the 208 was 19" Yes I will be selling the A-833 if anyone is interested...the 305 also
  5. S

    New Process A833 4speed w/ OD MY6 MM7

    Hello I actually have one of these transmissions. Still in the truck that I ordered back in 1986. A 305 with a 4 speed with overdrive. I was interested in saving gas which I forget how much a gallon it was then, but beyond anyone's imagination now. I am in the process of restoring the truck...
  6. S

    Small Block Chevrolet & transmission - $2000

    1986 Chevrolet Chevrolet K10 305 CID small block with A833 manual 4 speed w/overdrive transmission. Rare all original combination. Motor runs well and was well taken care of. Oil change every 2000 miles. Original power-train in pickup truck
  7. S

    Replacement Leaf Springs

    Thanks I beleive that I will use them. Stay away from ATS. They will send you what they want . Not what you need or ask for. Dealing with them has been miserable.
  8. S

    Replacement Leaf Springs

    I am replacing the leaf springs in the rear of my 1986 Chevrolet K10. I would like to retain the stock ride and height. The original springs are 4/1 or 5 leafs. Can anyone recommend a good replacement spring ?
  9. S

    Stuck spring and shackle bolts

    I am trying to take the rear out of my 86 K10. The rear leaf spring bolts came out pretty easy but the front bolts , of the rear leaf springs, closest to the cab wont budge. Any one know of a solution ?
  10. S

    Leaf Spring Recomendation

    So what would be the recommendation for stock height leaf spring replacement for a 1986 Chevrolet K10 ? There seems to be so many out there I thought I would ask the forum. I want to retain the same height. No lift.
  11. S

    1986 K10 Bed removal

    Thanks for all the advice. I dont want to grind the heads because the bed is pretty pristine. On 6 of the 8 i was able to get 3 -4 thread turns before the square part of the carriage bolt came out of its square hole. This allowed me enough room to put a cut off tool between the nut and bottom of...
  12. S

    1986 K10 Bed removal

    Hello All, I am having a lot of difficulty removing the carriage bolts that hold the bed onto my 1986 K10 Pickup. If I get them to turn a bit as soon as the square part of the bolt is higher than the square hole in the bed the bolt spins freely. The bolt is hard to get at to cut underneath...
  13. S

    Parking brake release spring

    Thanks All. The pictures are usefull because I couldn't tell where the other 'hanger' was for the spring. I could see one side but hopefully will be able to put a new spring in now that I know where it goes
  14. S

    Parking brake release spring

    OK, thanks again for the advice. BUT, now that I am thinking about what you said, the problem might be with the parking brake release handle. The brake works fine and is nice and tight. It is the handle that when I pull it it stays out. I will have to push it back in in order for the brake pedal...
  15. S

    Parking brake release spring

    Thanks all. I beleive that the problem is at the pedal itself. Boone, Couldn't I just replace the spring that is showing in the picture ?
See more

Latest posts

Forum statistics

Threads
42,070
Posts
908,370
Members
33,545
Latest member
GrayWK
Top