Recent content by ronniebomb
-
Fuse blows when fan speed on high
I was letting the truck warm up, and noticed no heat whatsoever. Prior to this, occasionally, the high speed wouldn't work. Or sometimes, nothing worked..........but if I messed with the blower speed switch flipping it up and down....it would start to work. The truck is intermittently driven...- ronniebomb
- Post #12
- Forum: Heat & AC
-
Fuse blows when fan speed on high
Did some research, and found this on another truck forum: "unplug the wire to the motor. Then replace the fuse, and try all settings on the switch. If the fuse doesn't pop, the fan motor is bad. If the fuse pops, its the relay or wiring If the fuse pops with the motor unhooked, leave the...- ronniebomb
- Post #9
- Forum: Heat & AC
-
Fuse blows when fan speed on high
I am also chasing the same exact problem on my 78 GMC K25. I have just spent the entire day replacing the blower motor, relay, and resistor. I cleaned all connections for the main power wire across the firewall. Still blows the fuse........... I guess I'm going to get quite familiar with my...- ronniebomb
- Post #8
- Forum: Heat & AC
-
78 GMC seat belt styles
Thanks for the input y'all! Ya know what's weird, the left-hand side male belt isn't retractable or doesn't have the hard plastic casing that would make it easier to grab and connect. It's just lays on the floor .............. and falls out of the truck when you open or try to close the door! I...- ronniebomb
- Post #8
- Forum: Interior
-
78 GMC seat belt styles
I have a 78 GMC K25 with only 54,000 miles. It was mostly original condition when I picked it up last year. It currently has lap belts, no shoulder harness on either side. My thinking was that in 74, GM went to the shoulder harness. Is there a possibility that the lap belt set up was an option...- ronniebomb
- Thread
- Replies: 14
- Forum: Interior
-
Wheel spacers
I just installed these on my K25. They work great and you don't need longer studs due to the recessed counter bores, and they even included 10 lug nuts for installation. They're on 'zon.......- ronniebomb
- Post #8
- Forum: Introduction
-
New guy. First forum account ever.
Welcome from n.e. ILLinoise!!!- ronniebomb
- Post #16
- Forum: Introduction
-
Hi, new member.
Welcome from north-east ILLinoise!!! That is one clean square, nice pick-up!- ronniebomb
- Post #18
- Forum: Introduction
-
new to the forum.....just picked up a sweet K25!
.....with that fine 409! A high school buddy has his dads 63 SS with the 409 dual quad 4 speed....... ear to ear grin behind the wheel for sure!- ronniebomb
- Post #41
- Forum: Introduction
-
-
new to the forum.....just picked up a sweet K25!
Is that a 64 SS in your avatar?- ronniebomb
- Post #39
- Forum: Introduction
-
new to the forum.....just picked up a sweet K25!
That's great info Craig! Thank you for the fuel pump knowledge, it all makes sense now after the fact! I would have never imagined a shorter fuel pump style for the 4wd's. I did rotate the outer lights 20° so they'd be correct. I never noticed on any truck until I installed these, now I pay more...- ronniebomb
- Post #36
- Forum: Introduction
-
-
Another newbie
Welcome from the state of ILL-inoise! Good to see another BBC powering a square!- ronniebomb
- Post #15
- Forum: Introduction
-
Another noob introduction
Welcome from the state of ILL-inoise!- ronniebomb
- Post #8
- Forum: Introduction
