There are inserts in the roof, but if yours are missing you can get a coarse screw/bolt that will tread into the sheet metal. A couple of mine are like that, just dont tighten them too tight, and I put a dab of silicone on the threads.
Don't know if the measurements might come out different if you have the barn doors or tailgate, I have a tailgate. The 2 rusty screws are for the air foil, the grey screw is the rear for the rack...
I have 3.42 gears and 33's and while it definitely wouldn't tow anything in 4th I leave it in OD all the time anything over 45mph and it cruises and pulls it just fine. Sounds like your TV cable needs adjusted, which is a pain in the ass in my opinion but I got mine set pretty good. If it's off...
Glasspacks sound good to me. If your thinking glasspacks equals loud thats because most people use short ones, the longer the glasspack the more quiet.
https://cherrybomb.com/project/glasspack/
Paid $40 for the one on my Ford Ranger and $60 for the one on my Suburban from Amazon and a local...
While you might be done with your 700R4 there's no reason it can't be a reliable transmission for you, it just needs to be built right. And by right I mean right parts installed by the right person.
Like I said I havent installed them yet so cant be 100% sure but I held them up in place and I think they would be fine on stock height, maybe a ziptie to be sure. And i think theyre for 4-6" lift.
20% is way better than any mod for any vehicle ever but not for the $2500 he had in it with brand new parts and install back in the 90's.
I would compare pricing to regear front and rear diffs.
I have an extended set from Rough Country for my 88' burb but havent put them on yet
https://www.roughcountry.com/extended-front-brake-lines-89360s.html
https://www.roughcountry.com/extended-rear-brake-line-89335s.html
Put these on my Suburban https://www.amazon.com/Bully-BBS-1103-4pcs-Black-Aluminum/dp/B01BIF9UI8/ref=sr_1_6?s=automotive&ie=UTF8&qid=1528695794&sr=1-6&keywords=truck+steps
OK it was the sending unit above the oil filter. Replaced it and pressure is reading normal again.
I'd still like to know what the square drive plug is for on the oil filter housing I'm still thinking of adding a mechanical gauge.
What about this plug above the oil filter that could be removed with the square drive of a 3/8 ratchet? I have access to plenty of fittings to add a mechanical gauge and would rather not T into the other sensors if I could have a dedicated source. Is this plug upstream or downstream of the...