Recent content by Fortrex

  1. F

    Rear Bumper Swap Questions

    I have an 84 pickup, currently has a 81-87 style front bumper and a fiberglass rollpan. I have a set of 73-80 bumpers laying around, I was wondering if anyone has ever put the 73-80 bumpers on an 81-87. I haven't been able to find any pictures of it and was wondering how it looks. The rear...
  2. F

    700r4 Popping into Neutral

    I double checked the linkage and it's adjusted properly and works freely through all the gears.. The truck has dual exhaust, it runs near the linkage but I don't see any marks to indicate any rubbing between the two.
  3. F

    700r4 Popping into Neutral

    I plan on double checking the linkage as soon as I can get it on the hoist. I thought there was no stop between O/D and neutral?
  4. F

    700r4 Popping into Neutral

    I thought that too, but side by side with a buddy's squarebody while punching it up to 4500rpms my motor seemed to flex a lot less than his did on his ~2 year old mounts.
  5. F

    700r4 Popping into Neutral

    I have a 1980 GMC pickup, 2wd single cab long box. The truck was a factory 350 oldsmobile diesel with a 3 speed auto, and the truck has been through a few different drivetrain combinations since then but it currently has a 305/700r4 combo. I believe the shift linkage is still the original 3...
  6. F

    DJM Drop Spindles Rotor Size?

    Never thought about actually calling the company up, I'll give them a call tomorrow and ask. Thanks.
  7. F

    DJM Drop Spindles Rotor Size?

    Wasn't trying to be an arse, if I was able to go pull off the rotor and check I would, not everybody has their truck with them with tools to do it and a location to do it in. If pulling it off and checking myself was an option it's pretty obvious I wouldn't be asking on here.
  8. F

    DJM Drop Spindles Rotor Size?

    Gee, thanks for that very helpful advice. I'm aware that I can pull off the rotor and check but I figured I'd ask here to see if somebody else knew before doing that.
  9. F

    DJM Drop Spindles Rotor Size?

    The only things cast into it are C10, LH/RH, DJM, and a capital L with a circle around it. No part numbers or anything.
  10. F

    DJM Drop Spindles Rotor Size?

    I picked up a set of DJM drop spindles second hand and was wondering how to tell if the spindles are the 1" rotor or 1.25" rotor ones. The axle, not including the "shoulder" at the base where it meets the knuckle, is 4.25" long. Also, from the pictures can anyone tell if they've already been...
See more

Latest posts

Forum statistics

Threads
42,075
Posts
908,501
Members
33,549
Latest member
kmousseau8
Top