Recent content by effnay
-
Curious where to buy one?
Sorry all, I don't have enough posts i guess to post in the wanted section. In need of 1 of these if anybody has one or can steer me in the right direction other than the LM place. Again, sorry to mis-post. Cheers- effnay
- Thread
- Replies: 0
- Forum: Electrical & Audio
-
86 Parking brake Release Rod
If anyone runs into this problem again, take a heat gun and slowly heat up the new handle to soften it up just a bit. Get the handle started and keep heat on it ( Not too much heat though ) while pressing it home. A second set of hands helps with holding the heat gun but can be done alone with a...- effnay
- Post #15
- Forum: Tech Discussion
-
-
Electrical Schematics
I'm just curious if anybody has a list for AWG sizes on a electrical schematic. I included a pic to help with what I'm asking. To start with, in the picture how do I determine what size the brown and light blue wires are circled in red. It says .5 LT BLU - 14 and .5 BRN - 9. In the green it has...- effnay
- Post #23
- Forum: Electrical & Audio
-
Blower Wheel?? (Need but can't post in wanted)
Hello all, I tried to post in the wanted section but I guess I'm too much of a noob for that so I'm asking here. I need a new blower motor wheel for my heater box resto. Not necessarily new but one that is not all chewed up like mine. Pretty much struck out at all parts stores and online... -
-
Front and Rear of driveshaft question...
Not really sure about the c10's having a center bearing, seems like I read about certain years having them,but mine does not. I have a 84. Guess I failed to mention that both ends are the same size, so u-joint or slip yoke will fit on either end. I would like to think it doesn't matter but...- effnay
- Post #3
- Forum: Differential & Driveline
-
Front and Rear of driveshaft question...
Hello all. I made kinda rookie mistake when restoring my driveshaft. When I pressed the yoke and u-joint out before painting it I failed to mark which end the trans yoke goes on and which end the u-joint for the rear goes. By the way, its a 84 c10 2wd Longbed. I took some measurements from...- effnay
- Thread
- Replies: 2
- Forum: Differential & Driveline
-
Slaving for the square
Hello all, Just stopping in here to say hello, before I start hassling you guys with my questions. Got a 84 c10 longbed I'm in the process of fixing up. Me and the guy have been together for 30 plus years. It was a TN truck all its life until bout 5 years ago he was trailered to damnit MI...- effnay
- Thread
- Replies: 12
- Forum: Introduction
-
Tranny Swap, need info on engine part?
well school me if you would please. is there a difference in the sensor vs switch?- effnay
- Post #4
- Forum: Tech Discussion
-
Tranny Swap, need info on engine part?
hello there all, first post here. been a lurker for many moons and have benefitted greatly from this site and i really appreciate the info i have gained on here. fixed many things by scanning over listing after listing. anyway... im in the process of removing the transmission out of my c10. i...- effnay
- Thread
- Replies: 4
- Forum: Tech Discussion
