Recent content by Dave1978
-
D
Vortec Heads vs OEM SBC Old School Heads
intake I've seen them as cheap as $75 on Ebay the ones to convert the heads to run with a carb.- Dave1978
- Post #10
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
D
82 to 85 grill and lites
Hey everybody I have a 82 c-10 with the 2 head light front end and I just bought an 85 4 light Silverado front clip. I was wondering If the 82 grill will fit in place of the 85 grill without much trouble.I have the wiring for both front clips.I would just like to keep my 82 looking like an 82... -
D
Vortec Heads vs OEM SBC Old School Heads
I like the vortec heads as well I have a set on ice for my next truck engine project.I read a test in a magazine years ago that tested all of GM aftermarket heads and they out flowed most.They are nice also with the center bolt valve covers cuts down on oil leaks a lot.- Dave1978
- Post #3
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
D
sheet metal repair sources
Hello everyone I just joined a week or so ago. I will be picking up my latest square on the weekend.1982 c-10 longbed straight 6 to be used for a work truck.It's not too bad for a Pennsylvania truck but it has rust in the usual spots.Question I have is who do you guys like for parts sources as...- Dave1978
- Thread
- Replies: 3
- Forum: Tech Discussion
-
D
New Guy from PA.
Hi my name is Dave I'm from Castle Shannon PA, just outside Pittsburgh I currently have a 1976 GMC Sierra 1500 4x2 with 325,000 not sure what I'm going to do with it(bad body PA winters) but it still runs good.I'm currently on the hunt for another square body for a daily driver.I've looked at a...- Dave1978
- Thread
- Replies: 5
- Forum: Introduction
