Recent content by Cucv_M1008

  1. C

    4l80 swap into a cucv m1008

    Column with stock shifter. Originally came with a th400
  2. C

    Need advice for doing Kilmat/Boomat/Dynomat

    Just did my floor yesterday, I used kilmat.
  3. C

    Cucv M1008 introduction/build, hello I'm new here.

    Im hoping to finish my floor install today.
  4. C

    Cucv M1008 introduction/build, hello I'm new here.

    More progress.
  5. C

    Cucv M1008 introduction/build, hello I'm new here.

    I found this forum a few weeks ago when I was looking for the pin out for my Vss cluster swap in my cucv. I figured I should write a hello post. I've had my cucv for about 14 years and it's been a forever project like most trucks. It started out as a stock cucv then I lifted it with a rear...
  6. C

    4l80 swap into a cucv m1008

    I've searched but I can't seem to find a answer, I have a ls swapped M1008 with A 4l80, I used the lokar shift linkage set up and I'm not sure if it's set right. I barely have to move my shift selcter on my column and it pops from P to R with very little movement. Un link the factory gear...
See more

Latest posts

Forum statistics

Threads
42,235
Posts
911,871
Members
33,738
Latest member
south456
Top