I can confirm the ord springs handle the weight well. Mine are a 5" lift with cross over steering. I like it alot. Rob bonnie mounts will probably be the best you can buy but I had good luck with aganfabworks.com. I did the weld it together yourself kit..
Ive done this swap in my 75 k20. I have an intercooled ve pump cummins with an nv4500 and a round pattern 205 t case with no adapters at all.. not too bad of a swap. almost no wiring needed haha. It helps to be able to weld but not a requirement.. No firewall cutting or rad support cutting for...
I personally run yellow top optima batteries in my truck.. I have read quite a bit about how odyssey batteries are way better by design but cost significantly more than an optima.. I currently have a red top optima that is almost 12 years old and still going strong ( I'm assuming this was pre...
off road design has a good steering box brace for about a 100 buckls IIRC. I personally went with a psc steering box with the ports in it for hydro assist if I ever wanted to go that route.. Do it once kinda thing.. I understand budgets though, so its not for everyone. I see nothing wrong with a...
I've been lookin for something like this.. I was thinking I might have to make my own. What I really like about the front hitch mount is that it will help make the frame more rigid too.
I absolutely agree about beefing it up. I have some 1/4' plate left over from my rear bumper I can make...