view: as if you were sitting in the driver's seat
View: as if you where laying under the dash with your left on the passenger side of the truck.
My truck is an 87 k or v10 whatever you prefer to call it. It's a factory 350/700 truck if any of that matters.
Sent from my HTC6500LVW using Tapatalk
Scored a jeep ujoint steering shaft anfter looking for one for months. Got it for $8.00 from pnp and it was already half way out.
Sent from my HTC6500LVW using Tapatalk
Not even done building the truck so there is no coolant even in it right now. I've only ran it long enough to time it. I will most likely run an aftermarket one too so I can monitor it better but I want the factory to work like it's intended to.
I thought that's what it was for but I wasn't...
I think I have gotten all of my wiring and vacuums lines figured out on this truck. When the po took it apart he didn't cut anything but he didn't mark anything either. I can't figure it where this one wire goes. I do t have the stick motor so I don't have anything to go off of. I have a 92...
Looking to get one of these shafts for my 87 k10 but can't seem to find any in my area if anyone has one they would like to sell please pm me a price.
Sent from my HTC6500LVW using Tapatalk
Already purchased one but if the price is right I'll get this one too. Are the pigtails that go with them possible too? Pm me where your at on the price and we can go from there.
Sent from my HTC6500LVW using Tapatalk
Just got done putting a 92 engine in an 87 and there are some differences such as the tps having a different connector and the alt and ac being on opposite sides. Oh and the temp sensor in the head of the newer trucks too it's there. Other than that they are pretty close.
Sent from my...
Just about done cleaning
All the wreckers are painted that way been that way for years . But we've got son big equipment down here and we don't play when it comes to using them either. We've got 4 50 ton Peterbilts and that 1/4 of the fleet.
Sent from my HTC6500LVW using Tapatalk